Constant temperature water tank liner adopts imported stainless steel plate, spray using ultrasonic humidification, compressor refrigeration, double vacuum glass door temperature and humidity digital display smart instrument can be installed micro-printer is the laboratory, the quality inspection center for cement concrete specimens ideal equipment maintenance.
Water circulation has been used for more than a year. Normally, the cooling rate seems to be getting slower and slower. The higher the temperature is, the more obvious it is.
Water recycling is simple, but regular maintenance work cannot be ignored. There are many seemingly faulty problems that are caused by regular maintenance. The electric power of the water cycle itself and the heat carried by the refrigerant from the load need to be drained from the radiator at the front hood. If the front hood is filled with dust, cotton, etc., it will hinder the dissipation of the heat, and the cooling effect will be Great discount. In general, cooling under normal conditions of use is due to poor ventilation and heat dissipation or high ambient temperatures.
When purchasing a constant-temperature water tank, the first consideration should be that deep-part imported water basins are not suitable for domestic large-scale pots and pans. Followed by the size, the bottom of whether there are measures to prevent moisture is also omissible, and pay attention to the following points: 1, according to the width of the cabinet to determine the width of the sink, the width of the general sink should be the width of the table minus 10-15 cm. When choosing a stainless steel thermostatic sink, the thickness of the material should be moderate, too thin will affect the service life and strength of the sink, and too thick can easily damage the washed dishes. Also look at the flatness of the stainless steel surface, such as poor description of poor quality. 2. Normally, the sink with large cleaning volume has good practicality, and the depth is better than 18 cm, which can prevent splashes from splashing. The surface treatment of the sink is beautiful and practical with the matt finish. Care must be taken to observe the joints in the sink. The weld must be smooth and even without rust. Beautiful appearance, reasonable design, with overflow as well.
Everyone knows that there is a small amount of impurities in the water, that is, after adding distilled water to the tank, it is impossible to completely guarantee that there is no impurity at all. For the water cycle, the general temperature is set at 20 °C, especially for the growth and reproduction of microorganisms. After a long time, these microorganisms will block the filter of the waterway and cause poor water return, and the water pump will have a loud noise. Sometimes these microorganisms attach to the surface of the heat exchanger, causing the heat transfer effect of the heat exchanger to deteriorate and the cooling capacity to become smaller. Therefore, we must strictly follow the instructions in the manual to do routine maintenance work, regular cleaning of the inner tank, long-term decommissioning to keep the tank dry.
There seems to be a leak in the water circulation. Sometimes there is a few drops on the ground. Is there a leak on the water?
In general, waterways will not leak during normal use. When the ambient temperature is relatively high, the relative humidity in the air is too large, the dew is likely to condense on the water pump, the water pipe connector, and the external water pipe in the water circulation water channel. After the accumulated water is dripped on the ground, there is no need to worry about water in the waterway. Leaking place. If you are concerned about this, turning on the air conditioner to lower the room temperature or dehumidify the dew.

CPE Cast Film Machine

CPE film machine ,Cpe casting film line, CPE cast film making machine, CPE cast film production line,Cast film line for CPE ,Lines for CPE cast film

CHANGLONGXING SCIENCE & TECHNOLOGY (SHENZHEN) CO.,LTD , https://www.clxmachinery.com