Safety precautions for using the light incubator When working in a light incubator, the following general safety measures must be taken. Failure to take these safety measures or to comply with the warnings described elsewhere in this manual will violate the safety standards for incubator design, manufacture, and use.
1, after the light incubator landing, such as uneven ground should be flattened.
2, in order to ensure personal safety, power outlet ground (E) to take over the earth.
3. When the incubator is in normal operation, placing the contents in the box should not affect the air circulation, so as to ensure uniform temperature and humidity in the box.
4. Incubator should be placed in a cool, dry, well ventilated place away from heat and sunlight. Keep it stable to prevent vibration and noise.
5. Always clean the surface and inner wall of the incubator to keep it clean.
6. The incubator should not be used for a long period of time. The power cord should be unplugged to prevent the incubator from hurting people by electrification. It is necessary to run it for 1 to 2 days according to the conditions of use, in order to avoid deterioration of some devices.
7, do 10 °C below the low temperature test, the ambient temperature should not be too high, the temperature difference between the inside and outside the temperature should not exceed 20 °C, in order to ensure the normal operation of the light incubator.
8. If the incubator malfunctions, it should be repaired by a professional or a manufacturer.

Small Engine Iridium/Platinum Spark Plug

Our company was set up in 2002.We are using the advanced cold punch technology to produce spark plug which is similar to NGK and Champion technology.With such technology, the metal shell and ceramic are better protected the quality of the spark plug are more stable to get avoid from air leaking and broken.Our spark plug products are ranged into more than 100 models with an anual out put of 6 million pcs. Besides the advanced technology,we also have a strong advantage of automatical production.Most of our production device is automatical that we have very high,efficiency and stable quality.Throughout such years of developing,we have gained a good reputation at domestic motorcycle manufacturer.Furthermore,our products have been exported to South East Asia, Middle East, Australia and so on. Revolution,refine and devotion are our principal of working.Welcome to visit us and raise your demand and your comments request are our target to strive.

Small Normal Spark Plug,350 Small Block Spark Plugs,Ngk Small Engine Spark Plugs,Small Engine Normal Spark Plug

LIXIN INDUSTRIAL & TRADE CO.,Limited , https://www.kgvsparkplug.com